FISH N MATE
Care Instructions:
Air pressure must be maintained at all times
Always wash your cart after saltwater use.(Car wash is ok)
Make sure all spring pins and cotter pins are in place before taking your cart out
Adjust the handle for proper height and be sure to keep the legs clear for travel
Load your cart with the weight to the back of the axle, Balance your equipment
Note: The rod holders were designed for carrying your rod only. It is your option to
use as a surf rod holder.
If necessary, use silicon spray for lubricatio9n on axle
Parts List:
#1 Main frame with #8 rod holders attached
#1 aluminum tee handle with foam grips
#2 5X15 ½” pneumatic tires
#1 5/8” axle 27” long
#3 2/16” X 1 ½” Ss detent pins
#4 5/8” ss Flat washers
#2 U-bolt assemblies: (#2 ¼”x 2 ½” u bolts; #4 ¼” Hex nuts; #4 flat washers)
#2 3/32” circle cotter pins
#1 15/16”X11 ¾” aluminum leg(front)
#1 15/16” X 0 ¾” aluminum leg(back)
#1 frame with cutting board
#5 6 3/8” screws for securing bait bucket
#1 plastic bait bucket
#8 plastic rod tube covers
Assembly Instructions:
Remove cart from container
Check all components with parts list
Remove all parts from main frame
Slide 5/8” axle thru u-bolts
Tighten u-bolts loosley
Measure axle to get centered on frame
Finish tightening u-bolts. Don’t over tighten
Put (1) 5/8” flat washer on each side of axle
Slide a 5X15 ½” wheel on each side of axle
Push a 3/32” circle cotter pin in hole on each side of axle
Put 15/16” foam grip tee handle in 1 1/16” tubing & align to desired height
Put 15/16” aluminum front leg in the 1 1/16” tube & align to desired height
Place cutting board with bait tray into any aluminum rod holder
Note: a back leg has been added to support the cart in the event you sit on the cart. It
Will prevent it from tipping, Remember to put the leg up and replace pin when moving
The cart.
Outside Frame:
10" High
19" Wide
47 5/8" Long
Inside Frame:
9" High
17 1/4" Wide
41 3/4" Long
